Painting Cedar Shake Sidings Seven Lakes Nc

Hang the shakes from a clothesline while they dry.

Painting cedar shake sidings seven lakes nc.

See the difference our team made in painting cedar shake siding to restore this house in phillipsburg nj. Exterior western red cedar surfaces only need to be refinished when the old coating has worn thin and no longer affords the wood protection. Painting bare cedar shakes that are already installed is very hard and can lead to other pesky problems down the road. Staining cedar siding differs from application of paint and other finishes.

Be careful when painting very old cedar siding. In refinishing painted or solid color stained siding and trim removal of the old coating may be required. Remove the shake and hold it over the bucket while wiping off the excess with a paint brush. The original cedar shake siding was faded and disc.

How to prepare old cedar shakes for repainting. These paints form a tough but flexible film that allows moisture within the wood to escape while protecting the cedar from atmospheric moisture that might lead to extractive bleed. While extremely old cedar can be painted it requires heavy preparation. Properly primed a 100 percent acrylic latex paint will provide decades of protection for cedar siding shingles.

The gap between the shakes acts like a miniature funnel in a driving rainstorm. Powerwash the siding to remove any excess dirt or paint with a low pressure pressure washer. Stains dry rapidly and fresh stain applied over dried stain will show lap marks. Even then the paint is not expected to last long.

A step by step guide to walk you through the pro. First remove any mill glaze a hard shiny surface on one side of the siding by sanding. Loosened photodegraded surface fibers and any loosened remaining finish must be removed prior to re finishing. The siding must be free from mold mildew and dirt.

Next dip each shake into the paint leaving only an inch or two not painted at the top where it is being held. One of the issues of painting cedar shakes after they are installed is that you don t get paint on critical parts of the shakes that can get wet. Remove as much of the old paint as possible as the more prep work you do. Pour the paint into a five gallon bucket.

Surface preparation is the key to success when dealing with weathered wood. Scrape any peeling paint chips off the shakes with a scraper. All done by hand to ensure full coverage.